stepping method

This paper proposes a transient analysis method of time-varying RLC network. At first, stepping variation of branch voltage is taken as a unknown variation, and then, the branch voltages and currents in network can be easily found with help of it.

本文提出了一种时变RLC网络的数值分析方法，它首先把支路电压的步进变化量作为待求变量，然后以此可很方便地求出网络中各支路的电压及电流。

Undr the control of frequency inverter and PLC ( Programmable Logic Controller), the general AC asynchronous motor can function as low rotate speed large torque stepping motor. The working principle, structure, adjusting and testing method of the motor system were introduced.

利用变频器和PLC可编程控制器进行控制，可以将普通交流异步电动机用作低速大转矩步进电机，文章介绍了这种步进电机系统的工作原理、系统构成和调试方法。

The collisions of liquid column or sphere have been investigated at either constant velocity or through coupling analysis through time stepping method.

最后文章采用时域步进法分析了球形大液滴与锥形结构的匀速砰击及耦合运动，对比分析了二者的差异。

In response to this, a slide mode robust control design is presented based on back-stepping method, and a control quantum is obtained through Lyapunov steady theory.

为此提出基于反演理论的滑模鲁棒控制方法，通过Lyapunov稳定理论获得控制量。

The performance of stepping motor depends on its driving method largely.

步进电动机的性能主要取决于其驱动方法.

Research on the Amendatory Method to the Fine Control Function of the Stepping Motor

步进电机细分控制函数修正方法研究

Douglas and Dupont deeply discussed the spline collocation methods for nonlinear parabolic: initial-boundary value problems in one space variable. They considered the use of orthogonal collocation method combined with various time-stepping procedures and got, some optimal results.

Douglas与Dupont在文献[1]-[4]中深入讨论了一维非线性抛物初边值问题的样条配置法，他们把正交配置法与各类时间离散方法相结合，得到了很好的结果。

This paper introduces the construction of control system in fuel cell electrical vehicle ( FCEV). The functions of the vehicle controller are analyzed. The processing method of pedal and stepping switch is discussed in detail.

介绍了燃料电池电动车整车控制系统的组成，分析了整车控制器的作用，详细讨论了踏板及档位处理方法。

In this paper, a new method of how to control stepping motors through a digital I/ O card based on Windows is presented.

介绍一种新的控制步进电机的方法，即基于Windows下通过程序采用数字I/O卡控制步进电机。

The paper mainly put forward a new control method of stepping motor which character-, ized by equal-stepped fine division, and then design a constant frequency PWM driver circuit.

提出一种等步距角的细分控制方法，并据此设计了恒频脉宽调制细分电路。

First of all, the principle and trait of PSpice which is the core of the simulation software, used in the circuit simulation is introduced. A new simulation method which is model-module-system stepping up is proposed based on applying the PSpice to the digital intelligent charging system.

文中首先介绍了仿真软件核心PSpice的电路仿真原理和特点，结合智能充电器系统的硬件特点提出了一种模型模块系统逐级向上的仿真方法。